English

Aluminum Foil Manufacturing Process IV-Testing

2016-07-14

Finishing processes

For many applications, foil is used in combination with other materials. It can be coated with a wide range of materials, such as polymers and resins, for decorative, protective, or heat-sealing purposes. It can be laminated to papers, paperboards, and plastic films. It can also be cut, formed into any shape, printed, embossed, slit into strips, sheeted, etched, and anodized. Once the foil is in its final state, it is packaged accordingly and shipped to the customer.

Quality Control

In addition to in-process control of such parameters as temperature and time, the finished foil product must meet certain requirements. For instance, different converting processes and end uses have been found to require varying degrees of dryness on the foil surface for satisfactory performance. A wettability test is used to determine the dryness. In this test, different solutions of ethyl alcohol in distilled water, in increments of ten percent by volume, are poured in a uniform stream onto the foil surface. If no drops form, the wettability is zero. The process is continued until it is determined what minimum percent of alcohol solution will completely wet the foil surface.

Other important properties are thickness and tensile strength. Standard test methods have been developed by the national government agencies. As a rule, thickness is determined by weighing a sample and measuring its area, and then dividing the weight by the product of the area times the alloy density. Tension testing of foil must be carefully controlled because test results can be affected by rough edges and the presence of small defects, as well as other variables. The sample is placed in a grip and a tensile or pulling force is applied until fracture of the sample occurs. So the force or strength required to break the sample is measured.To know more information please visit gzcleanroom.com.